Coleman 5151C Spezifikationen PDF herunterladen (Seite 13)

CEILING RINGS

The ceiling ring is to meet fire stop requirements. Acces-

sory Ceiling Ring (P/N 7660--2841) may be used, (see

Figure 10) or the mobile home manufacturer or the in-

staller may use other approved methods to stop fire.

If required, three (3) sections of Accessory Ring may be

used as shown in Figure 10B to provide closer clear-

ance around roof jack.

Figure 10 — Ceiling Rings

DUCT CONNECTORS

The duct connector is designed for use on ducts down to 12”

in width. When using the connector on smaller width ducts,

there will not be sufficient clearance to bend the tabs on two

sides of the duct connector.

In such cases the tabs may be attached to the sides of the

duct by using sheet metal screws or other suitable fasten-

ers. Holes for sheet metal screws are provided in three (3)

tabs on each side of the duct connector. If more than 3 tabs

need to be used to provide a more secure and air tight con-

nection, the remaining tabs can also be fastened to the duct

with screws after drilling the required screw holes.

If tape is used to provide a better air seal, it should be a type

approved by the applicable national or local codes.

TABLE 6 — Duct Connectors

Sales Package Part Number Depth

7681--6621 7681--602 2” Duct Connector — For Ducts 1--1/8” below top of floor surface

7681--6631 7681--603 3” Duct Connector — For Ducts 2--1/8” below top of floor surface

7681--6651 7681--605 5” Duct Connector — For Ducts 4--1/8” below top of floor surface

7681--6661 7681--606 6” Duct Connector — For Ducts 5--1/8” below top of floor surface

7681--6671 7681--607 7” Duct Connector — For Ducts 6--1/8” below top of floor surface

7681--6681 7681--608 8” Duct Connector — For Ducts 7--1/8” below top of floor surface

7681--6691 7681--609 9” Duct Connector — For Ducts 8--1/8” below top of floor surface

7681--6611 7681--611 11” Duct Connector — For Ducts 10--1/8” below top of floor surface

7681--6711 7681--612 12” Duct Connector — For Ducts 11--1/8” below top of floor surface

TEMPLATE & CUTOUT DIMENSIONS

14”

13--9/16”

11--9/16”

Duct Cutout

Dimensions

12”

NOTE:

Duct Connector may be used

positioned in any of four (4))

positions to fit duct.

Figure 11 — Duct Connector Dimensions

Casing Front

Door Front

15--7/8”

9--7/8”

12--1/4”

15--7/8”

1--13/16

9--3/4”

23”

1”

Floor Cut--out Line

Flue Center

Duct

Locating

Hole

1--15/16”

Figure 12 — Template

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Coleman 5151C Spezifikationen Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Coleman 5151C