Coleman 9955 Spezifikationen PDF herunterladen (Seite 11)

English - 10

Suggested Cleaning Materials:

r.JMEEJTIXBTIJOHMJRVJEEFUFSHFOUr)PUXBUFS

r8JSFCSVTIr1BQFSDMJQr/ZMPODMFBOJOHQBE

r4PGUCSBzTTCSJTUMFECSVTIr1VUUZLOJGFr4DSBQFS

Component Cleaning:

r BURNER: Wire-brush loose corrosion from the burner

exterior. Clean clogged gas port holes with an opened

paper clip. Replace corroded or damaged burner that

would emit excess gas.

r COOKING GRATE: Clean cooking grate with mild soap

and hot water. Remove stubborn residue with a mild

cleanser or scrub brush. DO NOT use a commercial oven

cleaner.

r GRILL INTERIOR: Remove grate. Scrape side with tools

and remove excess grease and cooking residue.

Fig. 33

Cleaning the Venturi

Spider’s nests or wasp’s mud inside the venturi may

cause re at the valve. If a re occurs, immediately turn

off the gas supply at the control valve (see representative

illustration in Fig. 32).

WARNING

REPRESENTATIVE ILLUSTRATION

Fig. 32

Fig. 35

Note:

Spiders and small insects can spin webs and build nests

inside the venturi tubes. This especially occurs in late

summer and fall before frost when spiders are most active.

These nests can obstruct gas ow and cause a re in and

around the burner knob. Such a re can cause operator

injury and serious damage to the grill. To help prevent a

blockage and ensure full heat output, clean and inspect the

venturi tubes often (once or twice a month). NOTE: Water or

air pressure will not normally clear a spider web.

Steps For Cleaning Venturi:

1. To remove the above obstructions, use an accessory

flexible venturi brush or bend a small hook on one end

of a 20-inch long flexible wire such as the one shown in

Fig. 33.

2. Remove the cooking

grate set aside.

(Fig. 34)

3. Using a screwdriver, remove the self-tapping screws

holding the burner clamps beneath the case and

remove the burner. (Fig. 35)

4. Look inside lower end of venturi tube for nests, webs or

mud. If present, clean as noted in Step 1, Fig. 33.

5. Inspect and clean the burner if needed.

6. Replace the burner and

burner clamps, and

position the burner in the

operating position.

7. Make sure the orifice

fittings are inside the

venturi tube, then tighten

all self tapping screws.

(Fig. 36)

Fig. 34

Burner

Venturi

Tube

Fig. 36

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Coleman 9955 Spezifikationen Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Barbrque & Grills Coleman 9955