19 20
TROUBLESHOOTING
Symptom Cause Solution
Output pressure varies high
and low. (continued)
Discharge nozzle is obstructed. Blow out or remove debris
with a fine needle.
Detergent is not working. Detergent container is empty. Add more detergent.
Detergent bottle or suction
tube not properly connected.
Check connections.
Detergent is too thick. Dilute detergent.
Filter on detergent suction
tube is clogged.
Run warm water through
filter to remove build-up.
Damaged or clogged
detergent suction tube.
Remove obstruction or
replace detergent
suction tube.
Nozzle is in high-pressure
position.
Use low pressure (black) tip.
Discharge nozzle is obstructed. Blow out or remove debris
with a fine needle.
Garden hose connection leaks. Loose fittings. Tighten fittings.
Missing/worn rubber washer. Insert new washer.
Spray wand, extension, or
nozzle leaks.
Spray nozzle not
properly attached.
Ensure quick-connect wand
is attached securely.
Ensure spray tip is clicked in
securely.
Broken o-ring or plastic insert. Call the Toll-Free Hotline.
Pump is noisy. Pump is sucking air. Check that hoses and
ttings are airtight. Turn o
machine and purge pump
by squeezing trigger gun
until a steady ow of water
emerges through the nozzle.
Water leaks from pump
(up to 10 drops per minute
is permissible).
Loose fittings. Check that all fittings are tight.
Water seals are damaged
or worn.
Call the Toll-Free Hotline.
Oil is dripping. Oil seals are damaged or
worn.
Call the Toll-Free Hotline.
TROUBLESHOOTING
IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED,
VISIT OUR WEBSITE AT WWW.COLEMAN-TOOLS.COM
OR CALL CUSTOMER SERVICE AT 1-888-202-1118 FOR HELP.
Symptom Cause Solution
Motor buzzes but fails to run. Supply voltage
below minimum.
Verify that only the pressure
washer is running on this
circuit.
System has residual pressure. Turn unit “OFF”, squeeze
trigger on spray wand to
release pressure, then turn
unit “ON”.
Voltage loss due to
extension cord.
Unplug any extension cords
attached and plug the unit
directly into the outlet.
Pressure washer not used
for long periods.
Call the Toll-Free Hotline.
Residual friction among
components. Unit might
hum.
Disconnect water supply
and power ON for 2 to 3
seconds, repeat couple
times or until the motor
starts.
No water. Quick-connect assembly is
attached in reverse.
Verify that Inlet adapter is
attached to machine’s water
inlet and that the quick-
connect coupler is attached
to garden hose.
Water supply is OFF. Turn ON water supply.
Kink in the garden hose. Remove kink in garden hose.
(11 Seiten)
(44 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern