Coleman Dual Fuel Installationshandbuch PDF herunterladen

ACCESSORY KIT INSTALLATION MANUAL

Johnson Controls Unitary Products 18630-UAI-E-0808

DUAL FUEL CONTROL KIT 3024-7481/F

FOR USE WITH MODELS: BRHS, BRHQ, DRHS, DRHQ, ERHS, ERHQ, THGD, GHGD, YHJD, CHJD, LHJD

SAFETY

IMPORTANT - These instructions are intended for the use of

qualified individuals specially trained and experienced in instal-

lation of this type of equipment and related system components.

Installation and service personnel are required by some states

to be licensed.

Persons not qualified shall not install this equipment or interpret

these instructions.

NOTE: The words “Shall” or “Must” indicate a requirement

which is essential to satisfactory and safe product performance.

The words “Should” or “May” indicate a recommendation or

advice which is not essential and not required but which may be

useful or helpful.

Installation and service personnel are required by some states

to be licensed.

Persons not qualified shall not install this equipment or interpret

these instructions.

The installer should comply with all local codes and regulations

which govern the installation of this type of equipment.

FIGURE 1: BRHS, BRHQ, DRHS, DRHQ, ERHS, ERHQ

THERMOSTAT

FURNACE

HEAT PUMP

3024-7481/F CONTROL

FIGURE 2: THGD, GHGD, YHJD, CHJD, LHJD

THERMOSTAT

FURNACE

HEAT PUMP

3024-7481/F CONTROL

Improper installation may damage equipment, can cre-

ate a shock hazard, and will void the warranty.

1 2 3 4 5 6 ... 11 12

Inhaltsverzeichnis

Seite 1

ACCESSORY KIT INSTALLATION MANUALJohnson Controls Unitary Products 18630-UAI-E-0808DUAL FUEL CONTROL KIT 3024-7481/FFOR USE WITH MODELS: BRHS, BRHQ

Seite 2 - APPLICATION

18630-UAI-E-080810 Johnson Controls Unitary ProductsFIGURE 11: Worksheet 2OUTDOOR TEMPERATURE °FBTUHX1000PER$140120100806040200-1001020306070804050300

Seite 3

18630-UAI-E-0808Johnson Controls Unitary Products 11SYSTEM OPERATIONAL CHECK-OUTNOTE: If a programmable wall thermostat is used on this appli-cation,

Seite 4 - 18630-UAI-E-0808

Seite 5 - NOTES FOR WORKSHEET 1

18630-UAI-E-08082 Johnson Controls Unitary ProductsLocal codes take precedent over any recommendations con-tained in these instructions. In lieu of lo

Seite 6

18630-UAI-E-0808Johnson Controls Unitary Products 3INSTALLATION ON GAS OR OIL FURNACEThe furnace must have a blower capable of delivering the airvolum

Seite 7 - HEATING PERFORMANCE DATA

18630-UAI-E-08084 Johnson Controls Unitary ProductsFIGURE 3: Wiring Diagram - 3024-7481/F Heat Pump Dual Fuel Control KitRREDYELYELYELBLKWHTFURNACE RE

Seite 8

18630-UAI-E-0808Johnson Controls Unitary Products 5NOTES FOR WORKSHEET 1FIGURE 6: Example Chart 1OUTDOOR TEMPERATURE °FBTUHX10007060504030201000102030

Seite 9 - NOTES FOR WORKSHEET 2

18630-UAI-E-08086 Johnson Controls Unitary ProductsDetermining the economical balance point:The KW values from the same heat pump application data ofF

Seite 10 - OUTDOOR TEMPERATURE °F

18630-UAI-E-0808Johnson Controls Unitary Products 7FIGURE 8: ERHS024 Extract from Technical Guide for ERHS018 thru 060 13 SEER R-22 Split System Heat

Seite 11 - Exceptions to the above:

18630-UAI-E-08088 Johnson Controls Unitary ProductsFIGURE 9: THGD24 Extract from Technical Guide for THGD24 thru 60 13 SEER R-22 Split System Heat Pum

Seite 12 - Norman, OK 73069

18630-UAI-E-0808Johnson Controls Unitary Products 9NOTES FOR WORKSHEET 2FIGURE 10: Example Chart 2OUTDOOR TEMPERATURE °FBTUHX1000PER$14012010080604020